Vermont Casting RHEDV25 - Manual (Page 30)

30 10000801
Vermont Castings, Majestic Products RHEDV Direct Vent Insert
B3 RHEFA and RHEFP Trims
For use with RHEDV32
Trim Assembly
1. Remove the front glass (see "Glass Frame Re-
moval" section).
2. Install support window trim channel, top and bottom
brass trim by using the shortest black screw. (Fig. 43
& 44)
Trim Top
Glass Frame
Trim Bottom
Screws
FP1295
Fig. 43 Install support window trim channel and top and
bottom brass trim.
Louvre
NOTE: Position brass
trim top as shown (small
end up) to prevent heat
discoloration
Glass Frame
FP1291
Fig. 44 Position brass trim top with small end up.
Vermont Castings, Majestic Products reserves the right to make
changes in design, materials, specifications, prices and discontinue
colors and products at any time, without notice.
IMPORTANT: Only trim panel assemblies approved
by Vermont Castings, Majestic Products can be
used on these products.
ALL repair parts will be available from your local dealer.
When ordering, always give the following information:
Model and serial number, part description with finish
and part number.
Key Description RHEFA RHEFP
1 Trim Window
Top/Bottom
52624-AB 52624-PB
2 Plate Decorative
Bottom
17597-AB 17597-PB
3 Top Louvre Assembly 57905 57905
4 Bottom Louvre
Assembly
57906 57906
5 Support Window
Trim Channel
57909 57909
6 Hinge 52356 52356
7 Fasteners Package
(Not Shown)
57916 57916
Bottom
Decorative
Plate
FP1292
Fig. 45 Slide bottom decorative plate under unit floor.
1
2
3
4
6
5
RHEFA & RHEFP TrimReplacement Parts
FP1296