Vermont Casting RHEDV25 User Manual
Page 32
32
10000801
Vermont Castings, Majestic Products RHEDV Direct Vent Insert
On units fitted with a Honeywell brand control
valve the location of the control knobs and
the ignitor button may vary slightly from those
shown in Figure 49. The Honeywell exten-
sion pieces are visually different in design
and are not interchangeable with the RN/RP
knobs shown in Figure 49.
2. Install the hanging brackets, as shown in Figure 50.
3. Install bracket on each side of the cabinet as shown
in Figure 54.
4. Install the two ceramic pieces inside the bay window,
as shown in Figure 46.
5. Install the bay window by hanging it onto the lower
tabs of the hanging brackets, as shown in Figure 51.
6. Install top louvre by engaging the oblong holes with
the upper tabs of the hanging brackets, as shown in
Figure 52.
7. Install brass trim to the steel frame as shown in
Figure 53.
Fan Control
Box
Extension
Bracket
KT207
Fig. 48 Attach the control box to the bracket and install
bracket into the cabinet.
Extension
Knobs
KT204a
Fig. 49 Install the knob extensions. (Only for RN/RP models)
Fan Control Box
KT205
Fig. 47 Remove fan control box.
KT212a
Fig. 53 Attach magnets and brass trim to the steel frame.
KT210
Fig. 51 Hang the window grille or the steel frame onto the
lower tabs fo the hanging brackets.
Hanging Bracket
KT209a
Fig. 50 Hanging bracket alignment.
FP1270
Fig. 54 Bracket for HEBTKP.
KT211
Fig. 52 Engage the slots in the upper grille top louvre witht he
upper tabs of the hanging bracket.