SUUNTO D9tx User Manual
Page 51

To assign a new transmitter code:
1.
Slowly open the cylinder valve fully to pressurize the system.
2.
Immediately close the tank valve, and quickly depressurize the regulator so that
the pressure is reduced to less than 10 bar/145 psi. Wait about 10 seconds, and
slowly open the cylinder valve again to re-pressurize to above 15 bar/300 psi.
The transmitter assigns a new code automatically.
NOTE
To pair on the new transmitter code, the Suunto D9tx code
must be cleared first.
To re-pair the transmitter with the new code and the Suunto D9tx dive computer:
1.
In the DIVE mode of the Suunto D9tx, long-press the DOWN button to enter the
DIVE settings. Enter the Tank Press Pairing menu (Refer to Section 5.8.3. Setting
the tank pressure pairing). Short-press the SELECT button to bypass the tank
pressure ON/OFF selection (the tank pressure transmission must remain ON).
2.
In the next menu, a Code number is displayed. Clear the code by short-pressing
the UP button (toggle from “Ok” to “Clear”), and press the SELECT button.
52