Sure Heat SGR30M Natural Gas Conversion Kit - Manual (Page 6)

Installing the NG regulator
NOTE: Make sure to use supplied pipe sealant on all non-flared
fittings.
1. Attach the tee fitting to the manifold as shown.
Tighten with wrench. (See Fig. 21)
2. .Attach the Connector 3/8” NPT x 3/8” UNF to
the tee fitting as shown. Tighten with wrench. (See
Fig. 22)
3. Attach the NG regulator to the tee fitting.
(See Fig. 23)
4. Attach one end of the supplied hose to the flare
fitting on the side of the tee connector.
(See Fig. 24)
The other end of the hose will be attached to the
side burner later.
Note: pay attention to arrow on the NG regulator
indicating direction of gas flow. The arrow
should point toward the grill.
Remember to apply pipe sealant to all non-flared
fittings!
This completes the NG regulator installation.
Converting the Side Burner to NG
1. Use philips head screwdriver to loosen the screw
6
SGR30M Natural Gas Conversion Instructions
Fig 21
Fig 22
Fig 23
Fig 24
arrow on the
back of regulator