Sure Heat VMO Vented - Manual (Page 8)

REMOTE CONTROL INFORMATION
TECHNICAL DATA
REMOTE CONTROL:
Supply voltage:
4.5V (three 1.5V “AAA” batteries)
Ambient Temperature Ratings:
0 - 60ºC (32 - 140ºF)
Radio frequency:
315 MHz
RECEIVER:
Supply voltage:
6.0V (four 1.5 V “AA” batteries)
Ambient temperature ratings:
0 - 60°C (32 - 140°F)
Radio frequency:
315 MHz
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
1). This device may not cause harmful interference, AND
2). This device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.
WARNING
The transmitter and the receiver are radio frequency appliances. If the
receiver is mounted inside metallic cases, severe loss of performances
(reduction of the range working) may result.
ATTENTION:
- Turn “OFF” main gas supply of the appliance during installation or
maintenance of the receiver.
- Place the receiver’s 3 position slider switch in the “OFF” position
during installation or maintenance.
- Turn “OFF” main gas supply of the appliance prior to removing or
reinserting the batteries in the receiver.
COMMUNICATION BETWEEN
THE REMOTE CONTROL
AND THE RECEIVER
To program the transmitter to the receiver,
move the three positions slider of the receiver
in the REMOTE position and depress the
ON/OFF key of the transmitter. The System
has got an automatic learning mode that allows
the receiver to mate with a new transmitter in
the event that the transmitter must be replaced.
As soon as the receiver receives the first
correct command from any remote control it
captures the new address and then “beeps”
3 times to confirm the synchronization and
command execution.
Transmission
Light
ON/OFF
Key
Side
Slider
Child safety
function OFF
Child safety
function ON
CHILD SAFETY LOCK-OUT FEATURE
With this function it is possible to deactivate the remote control key.
BACKUP FUNCTION
If the batteries of the Receiver are low, the appliance
can be switched on manually by moving the 3
position slider switch on the Receiver to the ON
position.
INSTALLING BATTERIES
Install four (4) “AA”
batteries into the
remote receiver box
as shown on the left.
Install three (3)
“AAA” batteries into
the remote control as
shown on the left.