StarTech.com AP150WN1X1OG - Manual (Page 9)

Instruction Manual
5
Hardware Installation
1. Connect the included power adapter to an available wall outlet and the DC jack on
the PoE injector.
2. Connect an Ethernet cable from the LAN port of the PoE Injector to your LAN switch
or router.
3. Connect a second Ethernet cable from the PoE port of the PoE Injector, the other
end of this cable will connect to the AP as instructed in the following steps.
4. Slide the bottom cover of the unit down to remove it and expose the ports.
5. Connect the Ethernet cable from the PoE port of the PoE Injector, to the PoE Port
port on the AP (closest to the antenna connector).
6. Slide the cover back on as shown.
Note: the AP may take approximately up to 2 mins to complete the power on
sequence.