beautypg.com

StarTech.com SV565UTPUEU User Manual

Page 16

background image

Instruction Manual

13

Beep Codes
Some of the keyboard command sequences you issue to the Remote Unit have multiple possible

settings. The Unit will beep to indicate what setting you have selected for the command you

issued. (A short beep followed by a long beep indicates an invalid command.)
[Ctrl] - [Ctrl] - [Alt]+[E] (Compatibility Mode)
1 beep: disabled
2 beeps: enabled

[Ctrl] - [Ctrl] - [F11] (Remote Image Quality Adjustment)
1 beep: 0 ~ 130 feet (0 ~ 40 meters) of UTP cable length
2 beeps: 130 ~ 260 feet (40 ~ 80 meters) of UTP cable length
3 beeps: 260 ~ 390 feet (80 ~ 120 meters) of UTP cable length
4 beeps: 390 ~ 500 feet (120 ~ 150 meters) of UTP cable length

[Ctrl] - [Ctrl] - [F4] (Typematic Rate)
1 beep: 6 characters/sec.
2 beeps: 12 characters/sec.
3 beeps: 20 characters/sec.
4 beeps: 30 characters/sec.
Note: Commands described in the [Key] - [Key] format are keys that must be pressed in order on

the keyboard. Commands described in the [Key]+[Key] format must be pressed simultaneously.
Note: If the NumLock, CapsLock, and ScrollLock lights are flashing in unison on the keyboard,

the other Unit has control of Computer A. You will not be able to use A until the other Unit

releases access to that computer.
Note: If the Extender is operating in Compatability Mode ([Ctrl] - [Ctrl] - [E] hotkey sequence),

you must enter [Ctrl] - [Ctrl] - [E] - [E] to access port E on the attached KVM switch.

This manual is related to the following products: