beautypg.com

Step 24: install the lp cylinder (lp models only) – Vermont Casting VM508K User Manual

Page 19

background image

19

50004825

VM508K / VM658K Assembly

CAUTION: Some parts may have sharp edges; to avoid injury, wearing gloves during assembly, lifting or mov-
ing the grill is recommended.

Step 24: Install the LP Cylinder
(LP Models ONLY)

Parts Required:

(1) LP Gas Cylinder (not included)

Figures 25 & 26
NOTE: Check your User’s Manual for the cylinder filling requirements, how to attach the regulator and how
to test for leaks before you try lighting the grill.
CAUTION: Make sure the hose is not touching any hot or sharp surfaces.
Place the LP Cylinder into the hole in the bottom panel. Next secure it from moving by lifting the cylinder
retainer wire and latching the bent edge over the lip of the cylinder. The final step is to connect the regula-
tor to the cylinder.
CAUTION: Do not turn on/ignite the grill until after performing a leak check at all gas connection points and
fittings. With the main LP cylinder valve OPEN, and ALL CONTROL KNOBS FULLY OFF, use a spray solu-
tion of 50% liquid soap and 50% water onto all gas connection points and fittings. The formation of bubbles
indicates an air leak that must be repaired and verified with this leak test before the grill is ignited.
NOTE: Ensure all plastic coatings have been removed from all stainless steel parts before using the grill.

����
������������
����

B119

Figure 25

����
��������������
����

B120

Figure 26

Step 19: Install Natural Gas Supply Line
(Natural Gas (NG) Models ONLY)

Figure 27
Run natural gas supply lne through bushing pro-
vided in back panel of grill.

����
����������������
�����

Figure 27

B240