Solvline Eddy Serial Ver 2.1.0.3 - Manual (Page 57)

Chapter7. Appendix
57
def v1readwrite
[enable, disable]
Disable
SNMP V1/V2 Attributes can read and write by SNMP
Agent.
In order to read attributes only change the feature to
"ReadOnly.‛
In order to read and write attributes change the feature to
"ReadWrite.‛
(Options : ReadOnly/ ReadWrite)
def v3readwrite
[enable, disable]
Disable
SNMP V3 Attributes can read and write by SNMP Agent.
In order to read attributes only change the feature to
"ReadOnly.‛
In order to read and write attributes change the feature to
"ReadWrite.‛
(Options : ReadOnly/ ReadWrite)
def v3username
[string]
eddy Configure the Username when use SNMP V3.
def v3password
[string]
none Configure the password when use SNMP V3.
def trapip
[address]
0.0.0.0
Configure the server IP address which receives the TRAP
information.
def trapoprt
[Socket No.]
162
Configure the server Port which receives the TRAP
information.
def trap_reset
[enable, disable]
Enable If Enable is selected, inform the "System reset info".
def trap_connect
[enable, disable]
Disable If Enable is selected, inform the "Serial Port opened info".
def trap_disconnect
[enable, disable]
Disable If Enable is selected, inform the "Serial Port Closed info".
def landhcp
[enable, disable]
Enable
If Enable is selected, DHCP server service will be enabled
on the LAN port.
def lanip Address>
10.10.1.1 Set the IP address on the LAN port.
def lanmask
255.255.255.0 Set the subnet mask address on the LAN port.
def lanstart Addrss>
10.10.1.2 Set the start address for the DHCP range on the LAN port.
def lanend Address>
10.10.1.30 Set the end address for the DHCP range on the LAN port.
def leasetime
180 Set lease time for DHCP.