SilentKnight SK-Zone-6 Addressable Six Zone Interface Module - Manual (Page 4)

FIGURE 7: RELAy CONTROL MODULE USED TO DISCONNECT A POwER SUPPLy.
(+)
(–)
(+)
(–)
(+)
(–)
(+)
(–)
(+)
(–)
SIGNAL LINE CIRCUIT (SLC)
32 VDC MAX.
TWISTED PAIR
IS RECOMMENDED
TO NEXT
DEVICE
RELAY CONTROL
MODULE
CONNECT MODULES TO LISTED
COMPATIBLE CONTROL PANELS ONLY
FROM PANEL
OR PREVIOUS
DEVICE
POWER LIMITED DC
POWER SUPPLY,
LISTED FOR FIRE
PROTECTION WITH
BATTERY BACKUP
C0248-02
C0142-01
— + — +
+0 +1
IDC ADDRESS
— + — +
+2 +3
IDC ADDRESS
— + — +
+4 +5
IDC ADDRESS
SLC
— + — +
A/B SELECT A/B SELECT
DISABLE
1
DISABLE
2
T6 T5
— + — +
+0 +1
IDC ADDRESS
— + — +
+2 +3
IDC ADDRESS
— + — +
+4 +5
IDC ADDRESS
SLC
— + — +
A/B SELECT A/B SELECT
DISABLE
1
DISABLE
2
T6 T5
IN OUT
— + — +
EXTERNAL SUPPLY
IN OUT
— + — +
EXTERNAL SUPPLY
EXTERNAL
POWER
SUPPLY
— +
PCB 1 PCB 2
VIEW A-A
0
1
2 3 4 5
6
7
8
9
BASE
ADDRESS
0
1
2 3 4 5
6
7
8
9
0
1
2 3 4 5
6
7
8
9
BASE
ADDRESS
0
1
2 3 4 5
6
7
8
9 10 11 12 13 14
15
10
11 12 13 14
15
FIGURE 8: ExAMPLE OF MULTIPLE BOARDS ShARING SAME ExTERNAL SUPPLy. REFER TO FIGURES 8 AND 9 FOR TyPICAL wIR-
ING. MAKE CERTAIN LIP ON LONG POwER SUPPLy jUMPER ENGAGES RETAINING TAB ON T5 OR T6 AS ShOwN IN vIEw A-A.
SK-460-008 4 I56-3441-000
© Silent Knight 2009
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
FCC STATEMENT