SilentKnight SD505-6SB 6 Sounder Base User Manual
Wiring, Specifications, Slc wiring
Table of contents
Document Outline
- SD505-6SB 6” Sounder Base Installation Instructions
- Wiring
- SLC Wiring
- Auxiliary Power Wiring
- Auxiliary Power Using Flexput™ Circuits
- 1. Connect the aux power wires to the Flexput terminals using “X” terminals as positive, and “O” terminals as negative power. See Figure 5.
- 2. Configure the auxiliary power output for constant output through programming (refer to Section 7.4 of the IntelliKnight 5820XL or IFP-1000 Analog/Addressable Fire System (P/Ns 151209 & 151139).
- Mounting
- Figure 6 : Mounting the SD505-6SB
- 1. Mount the extension base using the #8 1-1/2 screws through any of the extension base mounting holes. (See Figure 6.)
- 2. Connect Aux power and the SLC loop as shown in Figure 1, Figure 2 and Figure 4.
- 3. Connect wiring harness (P/N 140675) to the smoke base and SD505-6SB as shown in Figure 6.
- 4. Attach the smoke base to extension base (P/ N 120505) using the #8 1/2” screws, through the smoke base mounting standoffs. (See Figure 6.)