beautypg.com

Sigarms – SIG SAUER Universal Sight Pusher User Manual

Page 4

background image

General Note - No sight corrections should be made until the shooter
has become familiar with the firing characteristics of the pistol.

When zeroing, the target should be at 25 yards and the pistol should be
fired from a rested position (use single-action mode for best results - not
applicable if pistol is Double-Action Only). Sighting should be "point
of aim, point of impact."

1. Windage (left/right) - A change in windage is accomplished by
moving the rear sight either to the left or right in its dovetail. When
doing this, follow the rear sight rule: “To move impact left, move rear
sight left; to move impact right, move rear sight right”
. Moving the
rear sight 0.020 inches in the dovetail alters the point of impact by
approximately 3 inches at 25 yards.

2. Elevation (up/down) - For both the front and rear sights, 30 different
height combinations are available. The sights are numbered according to
their height. A change in elevation is accomplished by changing either
the rear or front sight. It is recommended that the rear sight be changed
first. The sight number is shown on each sight.

1" between number

2" between number

changes at 25 yards

changes at 25 yards

When changing the sights, remember this rule: “NUMBERS UP,
IMPACT UP; NUMBERS DOWN, IMPACT DOWN”
. This is true
whether it concerns the front or rear sights. Replacement sights in the
various height combinations are available from SIGARMS.

SIGARMS

SIGARMS

TM

TM

SIGHT ADJUSTMENT TOOL

SIGHT ADJUSTMENT TOOL

Sight Adjustment - General Information

Sight Adjustment - General Information

CARD-SAT 8/2002

Copywrite SIGARMS Inc. 2002

sigpro, SIGARMS & SIG Sauer
are Registered Trademarks of SIGARMS Inc.

Universal Sight Pusher 2002.qxd 9/25/2002 1:42 PM Page 4