SIG SAUER Universal Sight Pusher - Manual (Page 2)

* Remove Spacer for P239
in .40 S&W / .357 SIG
Front Sight Adjustment, Removal and Installation
1. Unload & field strip the pistol.
2. Install the slide on the Locking Plate from the front of the tool body. Ensure the
Alignment Head is centered allowing the rear sight to pass through its slot for
correct slide positioning within the tool.
3. Center the front sight blade in the narrow slot of the Alignment Head.
4. Tighten the Locking Plate Knob hand tight
5. Turn the T-handle to move the Alignment Head & sight in the desired direction.
Note: See the front page of these instructions for information that will assist
you in correctly installing your new sights.
SIGARMS SIGARMS TM TM SIGHT ADJUSTMENT TOOL SIGHT ADJUSTMENT TOOL
O O perating perating I I nstructions / nstructions / F F ront ront S S ight ight
Note: Diagram may vary from actual tool.
Universal Sight Pusher 2002.qxd 9/25/2002 1:42 PM Page 2