Firing and repeating – SIG SAUER BLASER Tac2 User Manual
Page 17

17
9. Firing and repeating
9.1 Firing and repeating
• Push the safety slide all the way for-
ward with the thumb in the “off safe“
position (see chapter 5.2).
• Sight the target.
• Pull trigger to fire rifle.
• Repeating: Pull back the bolt as far as
the bolt stop allows and then push it
forward again.
NOTE:
If the bolt handle is not in its most
forward position, the rifle will not fire
for safety reasons.
WARNING:
Do not move the safety to the
“off safe“ position until you are ready
to fire.
Keep your finger away from the trigger
unless you wish to fire the rifle.
When you interrupt or finish firing
move the safety slide immediately
backwards in the “on safe“ position.
Before making each shot, check the
terrain in front of and behind the
target.
Ensure that the target and the environ-
ment allow shots to be fired without
danger.
Always wear ear protection and safety
glasses when shooting. Alert
bystanders to the importance of wear-
ing ear protection.
If a cartridge fails, wait approximately
60 seconds before opening the breech
to avoid danger from a cartridge that
may be late firing.
WARNING:
You should never point the muzzle at anything, unless you are planning
to shoot, especially when you are loading and unloading the rifle.
Muzzle direction could be the difference between LIFE and DEATH.
R-93-LRS_2 6/8/01 2:32 PM Page 17