SIG SAUER BLASER Tac2 - Manual (Page 11)

11
4. Assembling, taking down
fig. 4
• Place both bolt rails parallel on the rear
end of the receiver and insert the bolt
by sliding the bolt rails forward (fig. 4).
Push forward on the bolt handle until
the bolt is closed completely.
NOTE:
Do not use force while inserting and slid-
ing the bolt forward. If you feel any resis-
tance pull the bolt back and repeat the
process.
NOTE:
Always make sure the bolt handle is
locked in the back position when
installing the bolt assembly, i.e. at an
angle of approx. 45°. If the bolt handle is
close to vertical, you cannot mount the
bolt assembly. Pull the bolt handle back
until it engages in the 45° position.
NOTE:
When assembling the rifle, ensure
correct magazine and bolt assembly are
fitted to match the caliber of the barrel
(see chapter 12+13).
WARNING:
Make sure there are no cartridges in
the chamber or magazine.
4.2 Taking down
• Push the safety slide forward slightly
with the thumb (approx. 1/16“),
simultaneously pulling the bolt handle
back (see chapter 5.5).
Then pull the bolt all the way straight
back.
• Unload the rifle (see chapter 10).
• Push down and hold the bolt stop pin
(see chapter 11.1) simultaneously with-
drawing the bolt assembly with the
other hand.
• With the 4 mm AF allen key supplied,
undo the two barrel attachment
screws, these are captive so cannot be
lost.
• Remove the barrel.
R-93-LRS_2 6/8/01 2:32 PM Page 11