SIG SAUER BLASER K95 - Manual (Page 7)

7
1.1. Hooking in barrel
This is only possible with the fore-end
removed.
Pull out extractor all the way to the stop.
Do not touch top lever. Place the
foremost barrel lug on the hinge pin. Due
to the tight fit, you have to proceed care-
fully. Grip barrel lug part and receiver with
one hand, press the barrel lug into its
bed, closing the rifle at the same time.
Hooking in the barrel requires a certain
degree of skill; but please refrain from
using force! The best solution is, to ask an
expert to show you the procedure and to
do it in his presence several times.
1. Assembling the rifle
CAUTION:
In the event of unskilful handling, the
breech block may, when the barrel is
tilted, slip out of its slightly inclined posi-
tion (pointing to the front) and snap
backwards into a vertical position (green
dot on the left side of the breech block is
not visible any longer). If this happens,
the rifle cannot be closed any more.
In this case push the top lever all the way
to the right, and with the other hand,
return the breech block into its slightly
inclined position (to the front).
K95 English 2001 6/8/01 2:40 PM Page 7