SIG SAUER BLASER K95 - Manual (Page 19)

19
4. Open sights
Due to differing sighting habits and re-
quirements, the rifle is tested and ad-
justed through open sighting in the plant
to an approximate degree of accuracy
only. Accurate test-shooting by adjusting
rear and front sight should be performed
by you, together with your dealer, to
allow the sighting to be tailored to your
personal requirements. 4.1. Front sight for height adjustment
- Insert the 1.5 mm AF allen key into the
hole of the front sight base and turn
the allen screw as required:
- Front sight (spring-loaded)
screw out = point of impact lower
screw in = point of impact higher
4.2. Rear sight (notch) for side
adjustment
- The sight has holes left and right for a
1.5 mm allen key
- Point of impact more to the left: loosen
allen screw on the right side, tighten
allen screw on the left side.
- Point of impact more to the right:
loosen allen screw on the left side,
tighten allen screw on the right side.
Please tighten allen screws with
sensitivity.
K95 English 2001 6/8/01 2:40 PM Page 19