Power source, Cleaning, Installation (continued) – Shellab SRI20PF User Manual
Page 13
13 |
P a g e
INSTALLATION (CONTINUED)
4. Repeat the process on the opposite side of the chamber with the second sliding mounting
bracket.
5. Hang 1 shelf from the 2 installed sliding mounting brackets.
P
OWER
S
OURCE
Always position the unit so the end-user has access to the power plug.
Check the data plate for voltage and ampere requirements before making a connection. If the
requirements match your power source, plug the power cord into an earth grounded outlet. This
incubator comes provided with a 100
– 120V 9ft, 5 in (2.86m) Nema 5-15P power cord. Supplied
voltage must not vary more than 10% from the data plate rating. Damage to the incubator
may result if supplied voltage varies more than 10%.
These incubators are intended for a 50/60 Hz application. Use a separate circuit to prevent loss of
product due to overloading or circuit failure.
Note: Electrical supply to the incubator must conform to all national and local electrical codes.
C
LEANING
The incubator interior was cleaned at the factory but not sterilized. See the
User Maintenance section for more information.