Seville Classics UHD20246B - Manual (Page 7)

Step 11. Insert Drawers.
WARNING:
NOTE:
Step 12. Place (#18) Drawer Mats .
Step 13. Install (#44) Lamp.
ASSEMBLY INSTRUCTIONS
(pg 6 of 8)
*NOTE: We recommend TWO people to assemble the workbench.
After sliding in the two Drawers, place (#18)
Drawer Mats inside the drawers or you can place
the (#18) Drawer Mats inside the drawers before
you slide them in.
A). Open lamp cover by press and lifting as shown
in the diagram below. Remove the cardboard
protective sleeve by twisting out the light tube.
Install the light tube and cover back to original
position.
B). Make sure the power cord goes through
Rubber Grommet of (#2-C) Top Pegboard Panel.
Attach (#44) Lamp under the assembled (#46) Top
Cantilever Shelf. Line up the screw holes, use
(#15) Screw B to tighten. Then place the (#18-1)
Top Cantilever Mat in place.
Pull out the drawer sliders and inner ball bearing
track completely. Then attach and fit the Drawer
to the inner track of the sliders and slide drawers
in.
Pull out the Ball Bearing track towards you.
Once you insert the drawers, tighten the screws
for (#48-1) Small Drawer Middle Support, (#48-
2) Small Drawer Left Support and (#48-3) Small
Drawer Right Support.
Pull the ball bearing
track towards you.