SeaLand 8700 Series MasterFlush Toilet Installation User Manual
Page 9
9
11. Loosen band clamp on discharge loop outlet and remove discharge adapter fitting/hose
fitting assembly (fig.
13
).
12. Lubricate discharge fitting assembly and inside end of discharge hose with liquid dishwashing
soap . Push discharge fitting assembly into discharge hose and connect with two hose clamps .
Be sure to position hose clamp screws 180° apart from each other (fig.
14
). Place toilet near
access holes and floor brackets.
13 . Connect toilet water line and 4-pin connector to water supply line and control module cable .
14. Position toilet over floor brackets and tilt toilet up from back. Push discharge assembly fitting
and hose up into discharge loop outlet. Lower toilet to floor and tighten band clamp (fig.
15
).
15. Turn on water supply and electrical power to toilet, and check for leaks. Press “Flush” switch
(fig.
4
2, page 2). If leak occurs, tighten connection.
16. At floor mounting holes, drill pilot holes for hex-head floor fasteners. Install fasteners and
washers using a 3/8 in. (10 mm) socket wrench (fig.
16
).
17. Cover floor fasteners with plastic covers (fig.
17
).
Dometic 8700 Series MasterFlush Toilet
Installation
12
15
16
17
14
13