SeaLand 8900 Series MasterFlush Operation Manual - Manual (Page 6)

6
Specifications SeaLand MasterFlush Toilet
6.1 Toilet system start-up
1 . Turn on water supply to toilet .
2 . Press “Flush” switch (fig .
3 2) once . After nine seconds of water flow, macerator pump will start
and run for about six seconds to clear bowl . It will take about five seconds to refill bowl .
3 . Toss several sheets of toilet paper into bowl and repeat
cycle . The bowl should completely clear .
6.2 Normal toilet operation
ADDING WATER TO TOILET BOWL
Press “Add Water” switch (fig .
3 1) until desired water level
is achieved . (Water flow will shut off automatically if switch
is pressed too long to avoid overflow .) More water is usually
added only when flushing solids .
FLUSHING TOILET
Press “Flush” switch (fig .
3 2), then release it . This activates a powerful macerator pump that
siphons water and waste from the bowl, macerates, and propels the effluent through the discharge
line to the holding tank .
6 Operation
Caution – Do Not Flush Foreign Objects!
Flush only water, bodily wastes and rapid-dissolving toilet
tissue . Do not flush wet wipes, sanitary napkins, condoms,
diapers, paper cups, cotton swabs, food, hair or liquids
such as oils or solvents as clogging or damage to the toilet
or toilet system may occur .
Note
Make sure all guests understand toilet operation before use .
Note
If toilet system is equipped with Dometic DFS
or DFP flush switch, flush controls and indicator
lights are shown at right .
3
1 2
4 3
DFS or DFP FLUSH SWITCH
DFT FLUSH SWITCH