SeaLand 140 VacuFlush Series Toilet - Manual (Page 4)

4
SYSTEM START-UP
1. Turn on electrical power to system.
2. Flush water into system by depressing flush lever until water starts flowing to the vacuum pump, about
15 seconds. This wets the pump interior for efficient operation. If vacuum pump does not run, check for
loose electrical connections.
3. The vacuum pump will run for approximately 30 to 90 seconds until system reaches operating vacuum level
and then will shut off.
TOILET OPERATION
IMPORTANT INFORMATION BEFORE OPERATION
1. Fill freshwater tank and add deodorant to holding tank through toilet bowl.
(See System Start-Up section.)
2. Make sure all guests understand the operation of the VacuFlush system
and the instruction label is in plain sight and easy for guests to read. If
this label is not included in this manual, please contact the SeaLand
Product Customer Service Department immediately.
3. Remember the vacuum pump starts automatically. Shut off the system before servicing and do not leave
the boat with toilet system breaker on.
4. Never use drain openers, alcohol, solvents, etc. in the system.
5. If the system does not function properly, refer to the Troubleshooting section of this manual and repair as
necessary. If problem persists, contact your local SeaLand product dealer.
1. To add water to the toilet before
using, raise flush lever until desired
water level is reached. Generally, more
water is required only when flushing
solids.
2. To flush toilet, press flush lever
sharply down to the floor. A sharp pop-
ping noise is normal when the vacuum
seal is broken. Hold lever down for
three (3) seconds. After flushing, let
flush lever snap back into original
position. If flush lever is accidentally
released before waste clears bowl, do
not attempt to flush toilet again until
vacuum pump stops running. A small
amount of water should remain in the
bowl after flushing.
3. Do not dispose of sanitary napkins
or other non-dissolving items in toilet,
such as facial tissue or paper towels.
These items can cause plugging of
the system.
NORMAL OPERATION
The toilet model identification label is located on the toilet base and will show
the model number and serial number.
NOTE: Make sure all guests understand the operation of the SeaLand toilet, and that the instruction label is
easy to read and in plain sight.
TOILET MODEL IDENTIFICATION