Reznor REC Parts Manuals - Manual

Form P-REC, P/N 271165, Page 1
IMPORTANT
1. If ordered with a heater, always include complete heater model
and serial number so that any specification change can be
considered for parts shipment. It can save time and expense.
2. Specifications are subject to change without notice.
3. We reserve the right to substitute functional replacements.
4. Order by Part No.; not Heater Option Designation.
Applies to : Replacement
Parts for Evaporative
Cooling Modules
Form P-REC (Version B)
Obsoletes P-REC (Version A)
Model REC
Evaporative
Cooling Module
Optional Evaporative Cooling
Module factory attached to the
inlet air opening
Applies to Sizes 300 and 500 of
Models ADF/ADFH; Model RPB;
Model RBA* blower cabinet; all
sizes of Models RGB*, AHCA*,
and PCCA*
Applies to Sizes 700 and 1200 of Models
ADF/ADFH; Model RBL Blower Cabinet;
and Models SSCBL and RPBL; and Models
PGBL* and RGBL*
Optional Evaporative Cooling Module
shipped separately for field installation
Evaporative Cooler
Information REFERENCES:
B
Ball Valve 2
Support Base 4
Box 2
C
Cabinet Parts 4
D
Drain 4
F
Fill an d Drain Kits 3
Float Switch 2
Float Valve 2
Freeze Protection 3
Fuse 2
Fuseholder 2
I
Intake Screen 3
M
Media Pads 2
Microprocessor 3
P
Moisture Eliminator Pad 3
Pad Clamp 3
Pad Rack 3
Pump 2
R
Relay 3
Time Delay Relay 3
Retainer Angles 3
Rubber Hose 2
S
Sprinkler Pipe Assy 3
Support Base 4
T
Temperature Controller 3
Terminal Block 2
Timer Assembly 2
Transformer 2
Transition Duct 4
V
2-Way Solenoid Valve 3
3-Way Solenoid Valve 3
Solenoid Valve 2
W
Water Hammer Arrestor 2
Index
Website: www.RezSpec.com
The following may be downloaded from the website:
Form I-REC, Evaporative Cooling Model REC Installation/Operation/Maintenance Manual
Form I-OPT-EC, IOM for shipped-separate Optional Evaporative Cooling Module
Form I-ADF, IOM for Direct-Fired Heater Models ADF and ADFH; evaporative cooling module for Sizes
700 and 1200 requires Installation Form I-OPT-EC
Form I-SSCBL/RPBL, IOM for "BL" heating Models SSCBL and RPBL; evaporative cooling module
requires Installation Form I-OPT-EC
Form I-RBL, IOM for Blower Cabinets; evaporative cooling module requires Form I-OPT-EC
Form I-RPB, IOM for outdoor indirect-fired Model RPB
NOTE: This booklet does not include replacement parts for optional evaporative cooling module on PREEVA ® Models. For replacement
parts for evaporative cooling on PREEVA ® Models (PDH, PEH, PXH, SDH, SHH, RDH, REH, RXH, RHH), see Form P-PREEVA.
* Model is no longer manufactured.