Reznor Q6SP Option - Installation - Enthalpy Sensor - Light Commercial - Manual (Page 2)

INSTAllER: PlEASE lEAVE ThESE INSTAllATION
INSTRUCTIONS WITh ThE hOMEOWNER
708883A (Replaces 7088830)
Specifications & illustrations subject to change without notice or incurring obligations.
O’ Fallon, MO | Printed in U.S.A. (07/11)
SENSOR MOUNTING
The C7400A2XXX Series sensor can be mounted directly on
to the sheet metal of the return air duct or can be mounted in
the air stream using the duct mounting kit (P/N 50053060-001).
Contact your local TRADELINE dealer for kit availability.
The duct mounting kit contains a rod to hold the sensor in the
duct, a flange to secure the sensor rod to the duct wall and to
fill the hole, and a gasket to prevent air from leaking through
the duct wall. See Fig. 1.
The rod has slots for threading the wire to prevent loose or
hanging wire in the duct and can be adjusted for 6 or 12 inch
length. The flange has extended relief for ease of mounting.
See Fig. 2.
ROD - 1 PIECE
FLANGE - 1 PIECE
GASKET - 1 PIECE
Figure 1. Duct Mounting Kit
(P/N 50053060-001)
WIRE HOLDER
EXTENDED RELIEF
(FOR CORRECT MOUNTING)
LENGTH ADJUSTS
TO 6 OR 12 INCHES
Figure 2. Duct Mounting Adjustments