Reznor CAUA Option - Installation - Vent/Combustion Air Kits - Manual

Form I-OPT-VC, Mfg #205892, Rev 8, Page 1
Description
and
Application
Installation of Horizontal (Option CC6) and
Vertical (Option CC2) Vent/Combustion Air Kits
for Reznor ® Separated-Combustion Systems
Form I-OPT-VC (Version F.2)
Obsoletes Form I-OPT-VC (Version F.1)
These vent/combustion air kits are designed to be used when installing the Reznor
separated-combustion equipment listed in the table. Follow the instructions in
the heater installation manual or venting manual shipped with the heater. The
kits identified as Option CC2 (vertical) and Option CC6 (horizontal) are the only
vent/combustion air systems approved for the models listed. Do not use these kits
with any other products.
INSTALLATION WARNING: This vent/combustion air kit must be installed according
to the instructions provided with the heater. If these instructions are not available,
contact your distributor to obtain the installation form listed in the Table above. The
qualified agency performing this work assumes responsibility for this installation.
APPLICATION WARNING: Separated combustion units are not designed or approved for use
in atmospheres containing flammable vapors or atmospheres heavily laden with chlorinated
vapors.
®
Application of Vent/Combustion Air Kit by Reznor ® Model Follow Instructions in the latest
version of the Heater Installation
or Venting Installation Manual:
Model Description Application
AHCA or
AHDA with SC
Furnace
Packaged Air Conditioning Split
System with Optional Furnace(s)
These models MUST be
installed as a separated-
combustion system
and always REQUIRE
installation of a Reznor®
vent/combustion air kit,
Option CC2 or Option CC6.
Models SSCBL, SSCDBL,
AHCA, and AHDA with more
than one furnace section
require a vent/combustion
air kit for each furnace
section.
Form I-AH-GF
HSC Duct Furnace (High CFM)
Form I-SC
SC Duct Furnace (Std CFM)
SCE Single Furnace Packaged System
Form I-SCE
SDH Single Furnace Packaged System
Form I-SDH-V
SFT Fan-Type Unit Heater
Form 432
SHH High Efficiency Packaged System
Form I-SHH-V
SSCBL 1, 2, or 3 Furnace Packaged System
Form I-SSCBL
SSCDBL 2 or 4 Furnace Packaged System
UDAS Fan-Type Unit Heater
Form I-UD-V-SC
UDBS Blower-Type Unit Heater
UEAS High Efficiency Unit Heater
Form I-UEAS
CAUA Vertical (Upflow) Packaged System
IF installed as a separated-
combustion system, Option
CC2 or CC6 is required.
Form I-CAUA
Verify parts and follow the instructions in the heater or
venting installation manual shipped with the heater.
(For a "generic" packing list of components, see page 2.)
Applies to: All Models Listed in Application Table