Reznor BE Option - Installation - Blower Guard (Options CD10 and CD12) - Manual

Form RZ-NA I-OPT-G, P/N 101542 (Rev 5), page 1
APPLIES TO: Models UDBP, UDBS,
B, and BE
Guards, Options CD10
and CD12
Installation Form RZ-NA I-OPT-G
Obsoletes Form 434/436-BG (Version A)
®
C E R T I F I E D
These guard options provide protection from the rotating belt drive and/or blower
components.
Blower Guard Option CD12 is designed for use with Models UDBP and UDBS
30-125 and Models B and BE 25-100 with a standard direct drive motor. Option
CD12 includes only the blower inlet guard.
Option CD10 is designed for use on Models UDBP and UDBS 150-400 and Mod-
els B and BE 50-400 with a belt driven motor. Option CD10 includes both the belt
guard and the blower inlet guard.
Description and
Application
Kit Components
FIGURE 1 -
Guard
Options
Blower Inlet
Guard in
Options CD10
and CD12
Belt Guard in Option CD10
Option CD10 includes:
Option CD12 includes: Option CD12 for B and BE 25-100 and UDBP and UDBS 30-125 Qty P/N
Option Pkg P/N 114548
Blower Inlet Guard 1 102474
Screws, #10-16 x 1/2" lg 4 37661
WARNING: Improper installation, adjustment, alteration, service, or maintenance can cause
property damage, injury or death. Read the installation, operation, and maintenance instructions
thoroughly before installing or servicing this equipment.
50-125 130-165 200-400
Qty P/N Qty P/N Qty P/N
Option Pkg P/N 101539 101540 101541
Blower Inlet Guard 1 102474 1 102475 1 102475
Screws, #10-16 x 1/2" lg for blower inlet guard 4 37661 3 37661 3 37661
Belt Guard 1 193796 1 193797 1 193795
Screws, #10 x 1/2" long for belt guard 5 11813 3 11813 3 11813
Contactor Mounting Bracket * 1 101405 N/A N/A
150-200 225-400
Qty P/N Qty P/N
Option Pkg P/N 202316 202317
Blower Inlet Guard 1 203079 1 102475
Belt Guard 1 193797 1 193795
Green Wire Assembly 1 202939 1 202939
8 37661 8 37661
Screws, #10-16 x 1/2" lg (4 for attaching blower inlet guard; 3 for
attaching belt guard; and 1 for attaching ground wire to blower)
Option CD10 for Models B and BE
*The contactor mounting bracket (the flat sheet metal part with four holes) and the two
additional sheetmetal screws are used only when the belt guard is being installed on a Model
75, 100, or 125 equipped with a motor contactor. Otherwise, these parts are not required and
may be discarded.
Option CD10 for Models UDBP and UDBS