Reznor PXH Option - Installation - Downturn Nozzle Installation - Indoor PreevA - Manual (Page 4)

Form I-PREEVA-DN, P/N212184R2, Page 4
Instructions (cont’d)
www.ReznorSpec.com; (800) 695-1901
©2014 Reznor LLC, All rights reserved.
Trademark Note: Reznor
® and PREEVA ® are registered in at least the United States.
05/14 (Serial No. Date Code BNE) Form I-PREEVA-DN (Version A.1)
FIGURE 5 - Installing
Vertical Louvers in
Option CD4 or CD5
1) On the notched end of the
louver, slide the spring over the tab.
2) When facing the unit, for airflow
to the left, push the tab with the spring
into a hole in the top louver frame
(compressing the spring) and insert
the tab on the other end into the
corresponding hole in the bottom.
For airflow to the right, push the tab
with the spring into a hole in the
bottom louver frame (compressing
the spring) and insert the tab on the
other end into the corresponding hole
in the top.
Wider side of the louver
blade must always be
facing out of the nozzle.
Airflow directed
to the left;
springs are
on the top.
Airflow directed
to the right;
springs are on
the bottom.
Front View of Installed Vertical
Louvers showing Airflow Direction
8. Applies to All Nozzles - Verify that the louvers are adjusted to provide the desired
throw pattern.
CAUTION: To avoid getting burned, adjust louvers while heater is not
in operation. If louvers are adjusted while heater is in operation, wear
protective gloves.
Installation of the nozzle option is complete.
If the heater is installed, turn on the electric. If installing on a gas heat model, turn on
the gas. Operate the unit and check for proper operation.
6. Install the Vertical Louver Frame
Position the assembled louver frame in the nozzle outlet so that the holes in the
tabs on each side are lined up with the holes in the nozzle. (The tabs fit between the
horizontal louvers.)
Using the screws in the kit, attach the tabs to the sides of the nozzle outlet.
7. Install the Vertical Louvers in the Louver Frame Using the Compression
Springs (See FIGURE 5.)
Before actually installing the louvers, note the louver curve and determine how the
louvers should be positioned to provide the optimal throw pattern. Depending on
where the heater is installed and the desired direction of airflow, louvers may be
installed with the curve all the same direction (either way) or the right half one way
and the left the other as illustrated in FIGURE 5.
a) With the wider section facing out of the heater, place one of the
compression springs over the tab on the notched end of the louver.
b) Depending on the throw pattern selected, the end with the spring can go either
in the top support or the bottom. See FIGURE 5. Slide the tab with the spring
into one of the holes in either the top or bottom support. Push the louver,
compressing the spring enough to place the tab on the other end into the
corresponding hole in the other support.
c) Continue installing the louvers until all vertical louvers are in place.
®