Ram Trucks 2014 3500 - User Guide - Manual (Page 25)

4. Attach the hook to the center tether strap loop (see diagram). Tighten the tether
strap according to the child seat manufacturer’s instructions.
NOTE:
If there are child seats in both of the
outboard (left and right) seating posi-
tions, the tether strap hooks of both child
seats should be connected to the center
tether strap loop. This is the correct way
to tether two outboard child seats.
Center Seat:
1. Raise the head restraint and reach
between the rear seat and rear glass to
access the tether strap loop.
2. Place a child restraint on the seat and
adjust the tether strap so that it will
reach over the seat back, under the
head restraint, through the tether
strap loop behind the seat and over to
the tether strap loop behind either the
right or left outboard seat.
3. Pass the tether strap hook under the
head restraint behind the child seat,
through the tether strap loop behind
the seat and over to the right or left
outboard tether strap loop.
Tether Strap Through Outboard Tether Strap
Loop And Attached To Center Tether Strap
Loop
Tether Strap Loop With Head Restraint In
Raised Position
Tether Strap Through Center Tether Strap
Loop
GETTING STARTED
23