Ram Trucks 2014 3500 - User Guide - Manual (Page 167)

IDLE-UP FEATURE (AUTOMATIC TRANSMISSION ONLY)
• The Idle-Up Feature uses the speed control switches to increase engine idle speed
and quickly warm the vehicle’s interior. This feature must be enabled by your
dealer. See your local dealer.
• With the transmission in PARK, the parking brake applied, and the engine
running, push the speed control ON/OFF switch on, then push the SET switch.
• The engine RPM will go up to 1100 RPM. To increase the RPM, push and hold the
RESUME/ACCEL switch and the idle speed will increase to approximately 1500
RPM. To decrease the RPM, push and hold the SET/DECEL switch and the idle
speed will decrease to approximately 1100 RPM.
• To cancel the Idle Up Feature, either push the CANCEL switch, push the ON/OFF
switch or push the brake pedal.
ENGINE MOUNTED FUEL FILTER/WATER SEPARATOR
Draining Fuel/Water Separator
• If the “Water in Fuel” indicator light is illuminated and an audible chime is
heard five times, you should stop the engine and drain the water from the
separator.
• The drain is located on the bottom of the Fuel Filter and Water Separator assembly
which is located on the driver's side of the engine.
6.7L CUMMINS® DIESEL
165