Pro Boat JR XR3i - Manual (Page 34)

34
Brake End-Point Adjustment
The Brake End-Point Adjustment, located at Grip Lever A,
allows the maximum servo travel on the braking side of the
throttle trigger to be increased or decreased from 100% to
0% (off). This function is very useful in race conditions as it
allows the racer to custom tailor the "panic" brake value to
maximize the car's braking power for the current track
conditions. Please note that since the Brake End-Point value
shown in the "BRK" screen is a percentage of the total
braking value established in the End-Point Adjustment
function (page 24), the value will not always increase or
decrease each time the Grip Lever A is moved.
Note: If Grip Lever A is assigned an Auxiliary
Channel 3 function by selecting "LN" or "2P"
with Grip Button C in use, the Brake End-Point
Adjustment will not be available.
To adjust the brake endpoint value, move the electronic Grip
Lever A either left (-) or right (+). As soon as the grip lever is
moved, the BRK End-Point Adjustment screen will appear
and will continue to be displayed unless the Grip Lever A is
untouched for a period of two seconds.
Current Value
(100% to 0%)
brk
50
E P A
Move the grip lever A to the left or right to decrease or increase values.
R/B
Decrease Increase
Grip Lever A
Brake Trim
Grip Lever A: Brake End-Point Adjustment BRK/Auxiliary
Channel 3 Access
4680 JR XR3i manual 7/17/02 12:14 PM Page 34