Perfect Aire 1PAMSH36-MZO4-16 Installation Manual - Manual (Page 7)

6
INSTALLATION INSTRUCTIONS
Fig.4
Correct orientation
of Installation Plate
Wall
Indoor
Outdoor
5-
7m
m
Fig.6
Fig.5
Indoor unit installation (wall-mounted type)
2. Drill a hole in the wall
Note:
1. Fit the Installation Plate
1. Fit the installation plate horizontally
on structural parts of the wall with
spaces around the installation plate.
2. If the wall is made of brick, concrete
or the like, drill five or eight 0.197 inches ( 5mm)
diameter holes in the wall. Insert Clip anchor
for appropriate mounting screws.
3. Fit the installation plate on the wall
with five or eight type “A” screws.
Fit the Installation Plate and drill
holes in the wall according to the
wall structure and corresponding
mounting points on the installation
plate. The Installation Plate may be
slightly different according to the
different models of indoor unit.
(Dimensions are in “inch” unless
otherwise stated)
1. Determine hole positions according
to the diagram detailed in Fig.5. Drill
one (1) hole (2.5 inches (65mm)) slanting slightly
to outdoor side.
3. Connective Pipe and Drainage
Installation
1. Run the drain hose sloping downward.
Do not install the drain hose as
illustrated in Fig.7.
Drainage
Fig.7
Do not block water flow by a rise.
Do not put the end of
drain hose into water.
Indoor unit outline Installation plate
11
.5
in
.
Right rear side
refrigerant
pipe hole 2.6in.
Left rear side
refrigerant
pipe hole 2.6
36.14in.
1.
8
7.28in. 5.91in.
A
1.
8
B
Right rear side
refrigerant
pipe hole 2.6in.
Installation plate Indoor unit outline
Left rear side
refrigerant
pipe hole 2.6
6in.(150mm) or more to ceiling
4.8in.(120mm)
or more to wall
4.8in.(120mm) or
more to wall
Model A (A: 28, B: 9.84, C:3.94, D: 4.33)
Model A (A: 28, B: 9.84, C: 3.94, D: 4.33)
Model A (A: 36.2, B: 11.5, C:5.9, D: 7.3)
Model B( ) A: 31.1, B:10.43, C:3.94, D: 5.9
Model B( ) A: 31.1, B:10.8, C:3.94, D: 3.35
Model C( ) A: 33.5, B:11.4, C:3.94, D: 4.53
Model B( ) A: 39.2, B:11.5, C:5.9, D:7.9
Model C( ) A: 33.5, B:12, C:5.9, D:5.7
1.
8
C D
6in.(150mm) or more to ceiling
4.8in.(120mm) or
more to wall
4.8in.(120mm)
or more to wall
Right rear side
refrigerant
pipe hole 2.6in.
Left rear side
refrigerant
pipe hole 2.6in.
1.
8
1.
8
6in.(150mm) or more to ceiling
4.8in.(120mm) or
more to wall
4.8in.(120mm)
or more to wall
1.
8
0
.2
-0
.3
in
.
(
)