Philips FW570C37 - Manual (Page 17)

TUNER
Easy Set ¡only in Standby or Demonstration mode)
EASY SET allows you to store all available radio stations
and RDS stations in a particular band (FM»I\/1W»LW)
automatically.
1 Press and hold STANDBY*ON (on the system only!
for 2 seconds.
— "CRSy SET" will be displayed and followed by
"TUtliR".
— Easy set will start with the last active band.
All available radio stations with sufficient signal
strength will be stored or until 40 presets are filled.
2 The system will search once again for the first
available RDS station and to set the RDS time
automatically.
• When searching RDS station;
-‘5ERREH PJJ5 STRTIOM'willbedisplayed.lf
no RDS station is available, the program will exit
automatically.
— After a station is found, "ERSy SET" will be
displayed and followed by "TIflE".
• When searching RDS time;
— "SERREH f?S5 TIflE” will be displayed.
When RDS time is read, "RUS TIME" will be
displayed. The current time is displayed for 2
seconds and will be stored automatically.
Notes:
- When EASY SET is used, all previously stored stations
will be erased.
- The last preset station or the first available RDS will
appear on the display when Easy Set is completed.
- If RDS station does not transmit RDS time
within 30 seconds, the program will exit automatically
and the display will show “NO RS5 TIflE".
Tuning to Radio Stations_____________________
1 Press TUNER to select TUNER mode.
— "TUNER" will be displayed.
— The preset station number, frequency and
waveband appear on the display.
2 Press TUNER (BAND) again to select the desired
waveband : FM, MW or LW.
3 Press TUNING ◄◄ or^ for more than one second,
then release.
-* The display will show "SERREH" until a radio
station with sufficient signal strength is found.
• Repeat this procedure until the desired radio station is
reached.
• To tune to a weak station, briefly press TUNING ◄◄
or ►► until the display shows the desired frequency
and/or when the best reception has been obtained.
S’
17