Philips RD0945T - Manual (Page 8)

Setting The Clock
(Can Only Be Done With Remote Control Unit)
П Press the Timer button. H—(-:++AM will blink or digits
indicating the time will appear on the screen.
NOTE; When resetting the time, press + button to initiate
the reset sequence, time digits will blink.
В Set the current time by using the number buttons 0-9.
NOTE: When setting time you must enter four digits. For
hour 1-9 enter "0" first, then desired time.
B When the current time is displayed on the screen,
press + button. The time stops blinking and "AM" or
"PM" begins to blink.
□ Select "AM" or "PM" with the number button "0" (AM/
PM).
B Press + button. The "AM" or "PM" stops blinking.
B After setting the correct time, press Exit button. The
Time display will disappear from the screen.
Setting The Timers
(Can Only Be Done With Remote Control Unit)
EVERY DAY TIMER
You can set the Timer to have the TV turn on a specific channel at the same time everyday.
(See opposite page for illustration steps)
D Press the Timer button three times to set the EVERY
DAY timer setting mode.
B If EVERY DAY timer has never previously been set,
"++ ++:-+-+AM" blinks, enter the desired channel
number using the Number buttons (enter "0" before
single digit channels). Then press + button. Digit(s) in­
dicating the desired channel will appear and the
"++:++" or digits indicating the time will blink.
NOTE: If resetting EVERY DAY timer, press the + button
to initiate reset sequence, then enter the desired channel.
B Set the desired turn on time using the Number buttons
0-9, then press the + button.
Q The "AM" or "PM" indicator will blink. Select "AM" or
"PM" with the "0" ("AM/PM") number button.
B Press the + button.
B Press the Status/Exit button.
ONE TIME TIMER
You can set the timer to have the TV turn on a desired channel at a preselected time.
(1) Press the Timer button in four times to set the ONE
DAY timer setting mode.
(2) Follow the steps (2) ~ (6) of EVERY DAY TIMER SEC­
TION.