Philips MX6050D-17 - Manual (Page 32)

Getting Started
Step 1: Inserting batteries
into the remote
control
O Open the battery compartment.
O Insert two batteries type R06 or AA,
following the indications (H------ ) inside
the compartment.
© Close the cover.
v.iii / ' !.•'
O Aim the remote control
directly at the remote
sensor (iR) on the front
panel.
0 Select the source you
wish to control by
pressing one of the
source select buttons on
the remote control (for
example TV.TUNER.)
O Then select the desired
function (for example
► ll,h^ ►►!).
Step 2: Setting the TV
IMPORTANT!
Make sure you have completed all
the necessary connections.
(See pages
12-13 “Connecting TV”.)
O Press SOURCE control until “SIBIT”
appears on the display panel (or press
DISC on the remote.)
O Turn on the TV and set to the correct
video-in channel. You should see the blue
DVD background screen on the TV.
Usually this channel is between the
lowest and highest channels and may be
called FRONT, AAf IN, or VIDEO. See
your TV manual for more details.
Or, you may go to channel 1 on your
TV, then press the Channel down button
repeatedly until you see the Video In
channel.
Or, the TV remote control may have a
button or switch that chooses different
video modes.
Or, set the TV to channel 3 or 4 if you
are using an RF modulator.
CAUTION!
- Remove batteries if they are
exhausted or if the remote is not to
be used for a long time.
- Do not use old and new or
different types of batteries in
combination.
- Batteries contain chemical
substances, so they should be
disposed of properly.
18