SoundMax SM-CDM1038 - Manual (Page 23)

22
Troubleshooting guide
Below is a table describing simple measures that can help you eliminate most problems likely to emerge
when this unit is in use. If below measures do not help, turn to a service center or to the nearest dealer.
Symptom Cause Solution
No power The car ignition is not on.
The fuse is blown.
If the power supply is properly
connected to the car accessory switch
the ignition key to “ACC”.
Replace the fuse.
Disc cannot be loaded. Presence of disc inside the
player. Remove the disc in the player then put
a new upward.
Disc cannot be read. Inserting the disc in upside
down.
Compact disc is extremely dirty
or defective.
Temperature inside the car is too
high.
Insert the compact disc with the label
facing upward.
Clean the disc or try to play a new
one.
Cool off until the ambient temperature
returns to normal.
No sound Volume is in minimum.
Wiring is not properly connected. Adjust volume to a desired level.
Check wiring connection.
The operation keys do not
work.
The built-in microcomputer is not
operating properly due to noise.
Front panel is not properly fix
into its place.
Press the power button for about 10
seconds to reset the unit
Sound skips. The installation angle is more
than 30 degrees.
The disc is extremely dirty or
defective.
Adjust the installation angle to less
than 30 degrees.
Clean the compact disc/try to play a
new one.
The radio does not work, The antenna cable is not Insert the antenna cable firmly select