Canon IMAGE FORMULA DR-6010C - Manual (Page 52)

Chapter 3 Basic Operation
3-22
Scan Panel Functions
The Scan Panel has the following functions.
a Start button
If Feeding Option is set to “Panel-Feeding,” clicking this button starts scanning.
b Stop button
Stops scanning.
c Job display
When the Start and Stop functions are assigned to the job buttons, [Start] and [Stop] are shown
here.
Note
If nothing is shown on the job display, the Start and Stop functions are not assigned to the job
buttons. In this case, you should use the Start and Stop buttons on the Scan Panel.
d Batch separation button
After selecting [Panel] as the batch separation setting on the [Others] tab, if you enable batch
separation from the application and start scanning, this button becomes active when scanning of
the current document completes, and scanning stops.
When clicked, this button depresses and remains depressed while scanning with batch
separation continues, until scanning of the current document completes, and scanning stops.
The button then returns to normal.
a
b
c
d