Configuring the fpga with the spi flash, Configuring the fpga / spi flash association – Connect Tech PCI-104 User Manual
Page 29
Connect Tech FreeForm/PCI-104 User Manual
Revision 0.02
29
Configuring the FPGA with the SPI Flash
In previous Xilinx FPGA configurations, the SPI flash required programming via 3
rd
party JTAG test
software or through in-system methods. The following features are new to ISE 9.1/9.2, and are only
available on select FPGAs, including the Virtex-5. Your FreeForm/PCI-104 card featuring the Xilinx
Virtex-5 FPGA includes a standard core to enable programming of BPI and SPI flashes over JTAG.
Configuring the FPGA / SPI flash Association
1)
Select “Boundary Scan” from the “Flows” tab.
2)
Right click on the FPGA and select “Add SPI Flash…”