Canon CDI-E144-010 - Manual (Page 131)

129
Troubleshooting
Trou
bleshooting
Image is blurred or
out of focus Camera moved z Hold the camera steady while pressing the
shutter button.
Autofocus function hampered by
obstruction to AF-assist beam. z Be careful not to block the AF-assist beam
flash part with a finger or other object.
The AF-assist beam is set to [Off]. z Set the [AF-assist beam] to [On] (p. 69).
Subject out of focal range. z Ensure that there is at least 45 cm (1.5 ft.)
between the camera lens and subject.
z Use the Macro mode to shoot close-ups
between 5 and 45 cm (2.0 in. to 1.5 ft.) from
the lens when set to wide angle and between
25 to 45 cm (9.8 in. to 1.5 ft.) when set to
telephoto.
Subject is hard to focus on. z Use the focus lock or the manual focus to
shoot the image. (See Shooting Problem
Subjects for the Autofocus (p. 92))
Subject in
recorded image is
too dark Insufficient light for shooting. z Set the flash on.
Subject dark in comparison to the
background. z Set exposure compensation to a positive (+)
value or use the spot metering function.
Subject too far for flash to reach. z When the flash is used, the distance between
lens and subject should not exceed 4.4 m
(14 ft.) at wide angle and 2.5 m (8.2 ft.) at
telephoto.
z Raise the ISO sensitivity and then shoot. (See
Changing the ISO Speed (p. 89))
Problem Cause Solution