CREATIVE AWE64 - Manual (Page 69)

2
Installing CTCM & CTCU
To install Creative PnP Configuration Manager (CTCM) and Creative
PnP Configuration Utility (CTCU) in DOS/Windows 3.1x:
1. Load the installation CD-ROM into your CD-ROM drive.
2. Exit to DOS if you are in Windows 3.1x.
3. At the DOS prompt, change to the drive containing your
CD-ROM. For example, type D: and press .
4. Type D:\ENGLISH\WIN31\CTCM\INSTALL
5. Follow the instructions on the screen to complete the
installation.
The installation program will install CTCM as a DOS device driver by
adding the following line to the CONFIG.SYS file:
DEVICE=\CTCM.EXE
where is the directory where you have installed CTCM.
This CTCM statement will be placed before all the statements that
load other low-level device drivers (such as CTSB16.SYS and
SBIDE.SYS) so that your Creative PnP cards will be configured
before these device drivers try to use them.
If you add this line to CONFIG.SYS manually, please make
sure that this line is placed after the statement (if any) that loads
the other PnP configuration manager in your system.
The installation program will also add the following lines to the
AUTOEXEC.BAT file:
SET CTCM=
\CTCU /S /W=
where and are the directories where
your CTCM/CTCU and Windows 3.1x files are installed respectively.