Clarity C600 - Manual (Page 20)

Memory Storage
20
5. The phone number is copied to the
EMERGENCY key.The LCD will display
MEM STORING for one (1) second and
the handset will give a success keynote.
Dialing the EMERGENCY Number
1. Unit must be in standby mode only.
2. Press the EMERGENCY key once.
3. The display will show the stored name
and number for 5 seconds. Otherwise
it will show -MEMORY EMPTY-.
4. Then the handset goes off-hook and dial
out the stored numbers.
Or
5. Press TALK key to make handset goes
off-hook.
6. Press the EMERGENCY key once.The
display will show the stored name and
number for 1 sec.Then the numbers
will be sent out.
Deleting the EMERGENCY Number
1. Unit must be in standby mode.
2. Press the EMERGENCY key once.
3. If this key has been programmed, the
display will show the stored number.
Otherwise, it will show MEMORY
EMPTY.
4. Press DEL/CH key once to delete this
number.
5. The display will flash DELETE ?.
Press DEL/CH key to move the cursor
back to character C.Then press any
other numeric key to change this
character.
10. Press ENTER to finish.The modified
characters and numbers will replace the
original phone record.
11. The display will show NUMBER
STORED.
Adding the EMERGENCY Number
1. Unit must be in standby mode only.
2. Press MODE key twice.The display will
show PHONEBOOK for 1 second and
then display the first available record.
3. Press the UP( ▲ ) or DOWN ( ▼ ) button
to go to the record to be stored to the
EMERGENCY key.
4. Press and hold the EMERGENCY key for
2 seconds.