Clarity C600 - Manual (Page 10)

Getting Started
Note: Remember, you must charge the
phone for at least 12 hours before you
use the phone for the first time.
BATTERY INSTALLATION
The C600 uses a 3.6Volt 600mAh NiMH
rechargeable 3 cell (AAA Type) battery that is
included with your unit.
Handset Battery Must be Connected
Before Beginning Initial Charging
To connect battery, remove battery compartment
cover and connect battery pack plug
into the battery connector and replace the
battery compartment cover.
Note:The battery in the handset must be
fully charged for 12 hours before using the
telephone for the first time.
To Install a New Battery:
1. Remove battery cover
2. Install new battery
3. Connect battery pack
4. Replace battery cover
5. Charge for 12 hours
before first use
Handset Battery Charging
1. Place the handset in the base.The
CHARGE LED on the base will light RED.
2. After the batteries are fully charged,
check for dial tone by pressing TALK
on the handset.
Low Battery
When the handset battery gets low, there will
be two (2) beeps every thirty (30) seconds and
the LCD screen will show BATTERY LOW. If
the battery becomes low while you are on a call,
you will be disconnected after about two (2)
minutes.Terminate the call and recharge
the battery.To recharge the battery pack, place
the handset in the base.
The battery charge can also be monitored via
the battery charge icon.This icon appears while
the phone is in the stand by mode and indicates
the condition of the batteries.
1. Make sure the contact points are
touching and the CHARGE LED is lit.
2. Be careful not to short battery with
conducting materials such as rings,
bracelets and keys.
Battery Life
A fully charged battery provides an average talk
time of about four (4) hours, or standby time of
about (8) days.
Talk time and standby time may vary depending
on operating conditions.
10
Installing and Connecting Battery