On Networks N150R User Manual - Manual (Page 70)

Advanced Settings
70
N150 WiFi Router (N150R)
3. Select the Private check box if you want to limit access to the LAN only. If Private is
selected, the static route is not reported in RIP.
4. Select the Active check box to make this route effective.
5.
Type the destination IP address of the final destination.
6. Type the IP subnet mask for this destination. If the destination is a single host, type
255.255.255.255
.
7. Type the gateway IP address, which has to be a router on the same LAN segment as the
N150R router.
8. Type a number from 1 through 15 as the metric value.
This value represents the number of routers between your network and the destination.
Usually, a setting of 2 or 3 works, but if this is a direct connection, set it to 1.
9. Click Apply to add the static route.
Remote Management
The remote management feature lets you upgrade or check the status of your N150R router
over the Internet.
 To set up remote management:
1. Select Advanced > Remote Management.
Note: Be sure to change the router’s default login password to a secure
password. The ideal password contains no dictionary words from any
language and contains upper-case and lower-case letters, numbers, and
symbols. It can be up to 30 characters.
2. Select the Turn Remote Management On check box.
3. Under Allow Remote Access By, specify the external IP addresses to be allowed to access
the router’s remote management.