OmniSistem Beta 3 – R4/R8 - Manual (Page 12)

COMPACT LINE ARRAY SOUND REINFORCEMENT SYSTEM
10
INSTALLATION
INSTALLATION METHOD 4 (THE LONG FLYING FRAME IS OPTIONAL)
INSTALLATION METHOD 5
Multi clusters flown from front to back
(maximum 4 clusters)
One cluster flown from front to back
Open the package, take out R4, R8 speakers and
the accessories.
Open the package of the long flying frame, take out
the frame and accessories.
Mount the M8 rings to the long flying frame (see
Arrow 1), and insert the R4 Back Link inside the
middle groove of the long flying frame (see Arrow 2).
Put the long flying frame upside down (with the rings
downside).
Demount the two M5 thumb screws at the top of
the front side of R4.
Put the R4 upside down. Insert the Front Links of
the long flying frame into the U grooves along the
left & right front edges of R4, make sure the two
screw holes on both sides are aligned, and then
tighten two M5 thumb screws through the holes.
Turn the R4 speaker, make the scale line marked
with the number of 0 on the R4 link attached to the
long flying frame aligned with the bottom edge of
the U groove, then insert a M5 thumb screw through
the two aligned holes and tighten it (see figure 4).
Demount the two M5 thumb screws at the bottom
of R8, and take out the R4-R8 Link. Then demount
the four M5 thumb screws connecting the R8 and
the short flying frame, and disassemble the short
frame.
Put the R8 upside down, insert the four links on
the back of the long flying frame inside the U grooves
of the R8 and make sure the screw holes are aligned
accordingly. Then mount and tighten two M5 screws
through the holes.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
1
2
3
5
4
No.1 Hole
No.2 Hole