OmniSistem Beta 3 – R4/R8 - Manual (Page 11)

COMPACT LINE ARRAY SOUND REINFORCEMENT SYSTEM
9
INSTALLATION METHOD 2
INSTALLATION
Multi Clusters Flown Vertically
(maximum 4 Clusters)
INSTALLATION METHOD 3
Cluster stacked with R8 at the bottom.
(1) Open the package, and take out R4 R8 speakers
and the accessories.
(2) Mount the four M8 rings to the flying frame.
(3) Demount the two M5 thumb screws at the bottom
of R8, and take out the R4-R8 Link. Disassemble
the U grooves and remount the two M5 small head
screws in the original holes.
(4) Disassemble the flying frame of another R8, mount
this R8 to the bottom of the first R8 by tightening
M5 thumb screws accordingly.
(5) Demount the two M5 thumb screws at the top of
the front side of R4.
(6) Insert the two R8 Front Links into the U grooves
along the left & right front edges of R4, make sure
the two screw holes on both sides are aligned, and
then tighten the screws through the holes.
(7) Insert one end of the R4-R8 Link into the U groove
on the back of R4 and the other end into the U
groove on the bottom of R8, make sure the two
screw holes at both ends of the link are aligned with
the corresponding holes in the U grooves, mount
the two M5 thumb screws, and tighten them (see
Figure3). Alignment of the white scale lines on the
R4-R8 link with the edges of the two U grooves
indicates successful mounting.
(8) Attach one or more clusters of R4 to the bottom of
the installed R4 accordingly.