OmniSistem PR Star Brite - Manual (Page 3)

3/16
SAFE USAGE OF THE PRODUCT
When unpacking and before disposing of the carton, check there is no transportation damage before using the product.
Should there be any damage caused by transportation, consult your dealer and do not use the apparatus.
The product is for indoor and outdoor use, but not allowed to be used outdoor in rainy days. Use only in dry locations.
Keep this product away from rain and moisture, excessive heat, humidity and dust. Do not allow contact with water or
any other liquids.
The product is not designed or intended to be mounted directly onto inflammable surfaces.
The working environment temperature of the product is 0℃~40℃.
The product is only intended for installation, operation and maintenance by qualified personnel according to the manual.
Don’t open the product for maintenance by yourself and don’t attempt to dismantle and/or modify the product in any way.
When the LED StarBrite Controller is installed, please make sure the ventilation slots of the controller are not blocked.
If the fuse is damaged, use one of the same specification to replace it, and before doing repair work, make sure the
power is cut off.
Do not connect this device to any other types of dimmer apparatus.
Do not look at lighted LEDs from a distance of less than 40cm. Watching lighted LEDs from a short distance for a long
time is bad for your eyes.
Before installation, ensure that the voltage and frequency of power supply match the power requirements of the product.
Make sure that the power-cord is never crimped or damaged by sharp edges. Never let the power-cord come into contact
with other cables. Only handle the power-cord by the plug. Never pull out the plug by tugging the power-cord.
The product should be earthed by power plugs with three-pin, forbid using two-pin plugs in case of electrical shock.
If the LED StarBrite Controller is mounted onto a high place, besides using screws to fix it, for safety purpose, a proved
safety cord is used as a secondary safety fixing, and it should be attached as shown in the “installing the product” section
of this manual.
There is no user serviceable parts inside the product, before operating this product, please check all the housing of the
LED StarBrite Controller and the driving device is installed, and the screws are fixed in place. Do not open the housing
and never operate the product with the covers removed.
If the LED StarBrite Controller is put on a table, make sure the table is stable and fix the controller on the center of the
table. Do not put the controller on the fringe of the table in case of falling.
To preserve the environment, the product should be recycled at the end of its life according to the arrangement of related
department.
If you have any questions, don’t hesitate to consult your dealer or manufacturer.
Always disconnect from the mains, when the device is not in use or before cleaning it or
before attempting any maintenance work !