OmniSistem PR Star Brite - Manual (Page 11)

11/16
LED INDICATION
On Power on
Green
Off Power off
On DMX signal OK
Yellow
Off No DMX signal
MAINTENANCE
When a LED StarBrite is used or stored for a long time, dust and dirt will accumulate on its surface. To maintain an
optimum light output, prolong the product’s life and ensure its reliability, it is very important to carry out the maintenance
work.
Pay attention to the LED StarBrite’s cleanness every day. When lots of dust and dirt accumulates on the LED StarBrite,
flap or wobble the StarBrite in order to remove the accumulation. It is advised to clean the LED StarBrite once every three
months.
When the LED StarBrite Controller do not work, check the fuse on the power socket of the LED StarBrite Controller.
Once damaged, it should be replaced by fuses of the same specification only.
Any maintenance work should only be carried out by qualified technicians.
TROUBLESHOOTING
PROBLEM ACTION
The LED StarBrite Controller doesn’t switch on. ¾ Check the fuse on the power socket.
The LED StarBrite doesn’t respond to the
console.
¾ Make sure the yellow indicator on the panel is on, and the
DMX signal is OK.
¾ Make sure the DMX address is correctly configured.
The LED StarBrite can work normally, but
doesn’t respond to the LED StarBrite Controller.
¾ Make sure the 5-pin signal connection cable is correctly
connected.