Canon RE-350 - Manual (Page 12)

AUDIO
OUT
VIDEO S VIDEO RGB
R G
OUT EXIT
AC INLET
AC OUTLET
75 OFF ON
24/96
100/60 ID 0
ID 1
RS-232C
SYNC OFF ON IN B
R L SYNC
1 0
AC 100V
To connect the RE-350 to a monitor, use a commercially available BNC video cable. To use a video monitor
with the S-VIDEO terminal, use a commercially available S-video cable. Using S-video enhances picture
quality. Use the power cord included with the RE-350.
Connection
To protect the RE-350 as well as other equipment in use, make sure
all the equipment (if any) is OFF before connecting cables. Always
hold onto the plug section whenever connecting/disconnecting the
cables.
• See page 16 for connecting equipment. For details of operation,
refer to the instruction manual of the equipment to be used.
• If your computer has AV compatability, you can input images to the
computer by connecting your computer to the RE-350 with video
cables. If your computer is not AV compatible, a video capture
board is necessary.
MEMO
Video monitor
To VIDEO OUT To S-VIDEO OUT
When using a BNC video cable
When using a S-video cable
To S-VIDEO input terminal
To VIDEO input terminal
Power cord
To 120VAC
power outlet
NOTICE
11
■ Installation Site and Environment
1. Connect the RE-350 to a correct electronic source.
Source voltage: 120VAC ± 10%
Source frequency: 60 Hz
2. Install the RE-350 in a proper environment.
Temperature: 41°F – 95° F (5°C –35°C)
Humidity: 85% max (without condensation)
Rear panel