NORAC UC5-BC-WK01 - Manual (Page 27)

24
9 Connecting the Sensors to the CANbus
1. Connect the chassis roll sensor to the 3-way coupler (E10).
2. Fasten the 8-way coupler (E11) to the boom with cable ties.
3. Connect cable C03 from the valve module to the 8-way coupler (E11).
4. Connect the boom frame roll sensor to the 8-way coupler.
5. Connect the main lift sensor to the 8-way coupler.
6. Connect two cables (C05) to the 8-way coupler and route along the booms to the wing
sensors. Follow existing cables and hoses to be sure the cable will not be pinched or
stretched.
7. At the sensor brackets, attach a 2-way coupler with terminator (E20) to the sprayer boom.
The 2-way coupler with terminator is the white two way coupler. Plug the sensor and the
CANbus cable into the 2-way coupler.
8. Insert the 6-pin plugs (P03) into the remaining connectors on the 8-way coupler.
Ensure that all unused connectors are plugged with the plugs provided.