NORAC UC5-BC-WK01 - Manual (Page 19)

16
7.2 Roll Sensor Mounting Guidelines: Front Mounted Rigid Booms
1. When mounting the roll sensors, mount the lowest serial number onto the boom frame
and the highest serial number onto the chassis near the sprayer cab.
The Boom Frame roll sensor must be the roll sensor with the lowest serial
number. The Chassis roll sensor must be the roll sensor with the highest serial
number.
Figure 17: Roll Sensor Mounting on a Front Mounted Rigid Boom
2. Ensure the roll sensors are relatively level when the sprayer boom and chassis are level.
3. Both roll sensor cables must be pointing towards the right hand wing of the sprayer when
looking from the rear of the sprayer.
4. Ensure both roll sensors are mounted adequately and that the cables provide enough slack
to allow sufficient boom roll.