NORAC UC5-BC-WK01 - Manual (Page 21)

18
8 Module Installation
An optional module mounting bracket kit is available for purchase from NORAC. The
mounting brackets are compatible with control modules and input modules. One kit is needed
per module.
Item Part Number Name Quantity
B20 43708 UC5 MOUNTING BRACKET KIT (CONTROL AND INPUT MODULES) 1
8.1 Control Module
1. Refer to Figure 2 and Figure 19.
2. Securely mount the control module (E01) inside the sprayer cab using screws, cable ties or
optional brackets.
3. Connect the display terminal to the control module using the display cable. This display
cable must be connected to the end of the control module with only one Deutsch
connector.
4. Connect the power cable (C30) to one of the two CANbus connectors on the control
module. Connect the other end of the power cable to an appropriate power source
(Figure 20).
5. Route cable C01 from the other CANbus connector out of the cab through the floor hatch
(Figure 21) towards the input module. To access the floor hatch, pull up the mat and
unbolt the plate on the far right of the cab.
Figure 19: Control Module Mounting